TD-W8901G / TD-W8951ND Wireless Modem/Router

Name	Status	Indication
Power	On	The modem router is powered on.
Power	Off	The modem router is off. Please ensure that the power adapter is connected correctly.
ADSL	On	Line is synchronized and ready to use.
	Flash	The ADSL negotiation is in progress.
	Off	ADSL synchronization fails.
Internet	On	The network is available with a successful Internet connection.
	Flash	There is data being transmitted or received via the Internet.
	Off	There is no successful Internet connection or the modem router is operating in Bridge mode.
WLAN	On	Wireless is enabled but no data is being transmitted.
	Flash	The modem router is sending or receiving data over the wireless network.
	Off	Wireless function is disabled.
WPS
LAN 1-4	On	There is a device connected to this LAN port.
	Flash	The modem router is sending or receiving data over this LAN port.
	Off	There is no device connected to this LAN port.

Here is the guide to configure the TP-LINK TD-W8901G/TD-W8951ND Wireless Modem/Router

Type in http://192.168.1.1
Click on Interface Setup
1. Virtual Circuit make sure its set to PVC2 and select PPPoA/PPPoE
2. put in the vif username with the @vif.com at the end
3. put in password
4. Save the settings by pressing SAVE
Wireless Settings Configuration
1. Click on Wireless
2. change Use WPS to NO
3. Autentication Type select WPA-PSK/WPA2-PSK
4. put in password using 8-64 characters
5. Save the settings by pressing SAVE
Firewall
1. Click on Advanced Setup - Firewall
2. Firewall and SPI make sure its set to Disabled
3. Save the settings by pressing SAVE
Access Management
1. Click on Access Management - UPnP
2. UPnP and Auto-Configured make sure its set to Activated
3. Save the settings by pressing SAVE
Administration
1. Click on Maintenance - Administration
2. put in a password to change the default admin password (this is recommended)
3. Save the settings by pressing SAVE
Status