Put the Zyxel modem in Bridge mode

• In XP go to Start/Run, type: cmd | In Windows 98/ME so to Start/Run, type: command
• enter telnet 192.168.1.1 and press enter

• Password is 1234 and press enter

• You should see this screen next (The Main Menu)

• Now to set it as bridge mode, Type 1 in the “Enter Menu Selection Number:” and press enter . You should end up in the General setup menu

• In order for it to be bridge make sure “Bridge=Yes” (Follow exactly what you see in the previous picture). Then press enter to save changes . (in order to modify options you must press the Space bar)
• Once your back at the main menu, Type 4 in the “Enter Menu Selection Number:” and press enter. You should end up in the Internet Access Setup menu

• You must have these settings in order for bridge mode: (Just look in the picture above).
  1. Encapsulation = RFC 1483
  2. Multiplexing = LLC Based
  3. VPI/VCI = 0/35
• Press enter to save changes. After pressing enter you should end up at the main menu, Type 11 in the “Enter Menu Selection Number:” and press enter . You should end up in the Remote Node Setup Menu

• Type 1 and press enter and you should see this screen:

• Make sure you have these settings (look at the picture above)
  1. Encapsulation = RFC 1483
  2. Multiplexing = LLC Based
  3. VPI/VCI = 0/35
• After all that, Press enter 2 or 3 times to get to the main menu and type 99 in the “Enter Menu Selection Number:” to exit and thats it!

  Modem should connect with a PPPoE client now.