|
|
— |
en:2wire-hg-e [2010/02/16 21:48] (current) |
| ===== Setting the 2Wire Modem In Router Mode ===== |
| |
| To configure the 2Wire 2700HG-E modem/router to let it stay connected 24/7, you will need to edit a few configuration before log in into it. |
| |
| 1. Open a **browser**, in the address bar, type 192.168.1.254.\\ |
| 2. Click on "Internet Connection".\\ |
| {{en:2wire_2701hg_1.png|}}\\ |
| |
| 3. Click on "Advanced Settings" and it will ask you for a password to login, type: admin.\\ |
| {{:en:2wire_pic_1.png|}}\\ |
| |
| 4. Make sure the Settings is on DSL \\ |
| 5. Put the DSL Line Selection to "Automatic" then enter VPI as "0" and VCI as "35".\\ |
| 6. Set the ATM Encapsulation as "Bridged LLC".\\ |
| 7. Set the ATM PVC Search to "Disable".\\ |
| 8. Set connection Type as "PPPoE".\\ |
| 9. Enter your "username", "password" and "confirm password".\\ |
| 10. Set forced Upstream MTU as "1492".\\ |
| 11. Click Save.\\ |
| |
| {{:en:2wire_pic_2.png|}}\\ |
| |
| In a few minutes, try to browse the internet, you should be able to surf now.\\ |
| |
| ==== Optional ==== |
| |
| If you want to setup the wireless, here are the instructions for it. |
| |
| 1. Go on the "Home Network" page, then in "Wireless Settings"\\ |
| 2. Put a check mark on "SSID Broadcast" and "Wireless Network Security"\\ |
| 3. The Authentication could be set on WEP Open, WEP Share, WPA-PSK, best choice will be "WPA-PSK".\\ |
| 4. Use "Custom encryption key" and type the key you want. The default one is the one on the modem.\\ |
| 5. Finally, click "Save".\\ |
| {{:en:2wire_pic_3.png|}}\\ |
| |
| |
| ==== DMZ Plus ==== |
| |
| This section shows how to enable DMZ for some equipments, so there is no problem with the incoming and outgoing connection. |
| |
| 1. Go on the "Firewall" page, then in "Firewall Settings"\\ |
| 2. Select the equipment that you want. (as an example, I chose the Sipura)\\ |
| 3. Check "Allow all applications (DMZplus mode)\\ |
| 4. Then click "Save"\\ |
| {{:en:2wire_pic_4.png|}} |