Configuriation avec la console cable

What happens when a client clicks on the reset button. It sets the modem back to router mode, but this modem doesn't work under the router function. So we have to flash back to bridge mode. To flash the modem you have to have a console cable and go have hyperterminal. Follow these instructions:

  • Go to the hyperterminal. Start / Programs / Accessories / Communications / Hyperterminal


  • Next window just enter the name: Speedstream and press ok


  • Next window Choose Connect Using: COM1 or COM2 depends on where your serial cable is connected


  • Next window choose Bit per second: 9600 , Databits: 8 and press ok


  • Then you'll see the hyperterminal window just like this


  • Next follow these steps carefully
    • type: admin and press enter
    • type: admin and press enter again
    • type: bridge add interface wan0 and press enter
    • type: rfc1483 add trn rfc1483-0 atm 0 35 llc bridged press enter
    • type: bridge attach wan0 rfc1483-0 press enter
    • type: sys config save press enter

“Make sure not to copy paste the command the hyperterminal doesn't like it”

  • Try to connect after and you should be able to get online.
fr/5667console.txt · Dernière modification: 2006/03/15 16:12 (modification externe)
VIF Internet 2075 Bl Robert Bourassa #400 Montreal QC H3A 2L1 - 514-353-9988 / sans-frais: 888-321-3737