Faire un Flash dure sur le modem

Procédure for loader 5637 le firmware (fonction bridge)

Connecter le cable console sérial entre le 5637 and port COM sur le PC.

The console settings are:

Bits per Second: 9600

Data bits: 8
Parity: None
Stop bits: 1
Flow Control: None

1. Power off the 5637 modem.

2. While holding the space bar, power on the 5667 modem.

3. The 5667 modem will enter boot mode, you should see the following:

Entered console …… User request

 [ _

4. Enter the command: xmodem fast

5. At this point you must change the Bit per Second configuration from 9600 to 38400. Select the disconnect button from HyperTerminal, change the Bits per sec, and re-connect..

6. Select the Transfer pull-down menu and choose the Send.

7. Click on the Browse button and locate the *.bin file. (5667_Tobago_R3[1][2].1.0.bin located on c:\)

8. Make sure that you select xmodem as the transfer protocol.

9. Click Send, this will take approximately 5 minutes.

10. Once the firmware upgrade is complete, type quit.

11. At this point you must change the Bit per Second configuration from 38400 to 9600. Select the disconnect button from HyperTerminal, change the Bits per sec, and re-connect

12: The 5637 modem will start-up again.

13. Once the modem is up, log on via the console, the default password is admin.

14. Enter the command flashfs update

Don’t worry this flash puts the modem directly to BRIDGE

 
fr/5637flash.txt · Dernière modification: 2006/03/15 16:09 (modification externe)
 
VIF Internet 368 Notre Dame O. suite 200 Montreal QC H2Y 1T9 - 514-353-9988 / sans-frais: 888-321-3737