Configuring with the console cable

What happens when a client clicks on the reset button. It sets the modem back to router mode, but this modem doesn't work under the router function. So we have to flash back to bridge mode. To flash the modem you have to have a console cable and go have hyperterminal. Follow these instructions:

  • Go to the hyperterminal. Start / Programs / Accessories / Communications / Hyperterminal

hyper.jpg

  • Next window just enter the name: Speedstream and press ok

hyper1.jpg

  • Next window Choose Connect Using: COM1 or COM2 depends on where your serial cable is connected

hyper2.jpg

  • Next window choose Bit per second: 9600 , Databits: 8 and press ok

hyper3.jpg

  • Then you'll see the hyperterminal window just like this

hyper4.jpg

  • Next follow these steps carefully
    • type: admin and press enter
    • type: admin and press enter again
    • type: bridge add interface wan0 and press enter
    • type: rfc1483 add trn rfc1483-0 atm 0 35 llc bridged press enter
    • type: bridge attach wan0 rfc1483-0 press enter
    • type: sys config save press enter

“Make sure not to copy paste the command the hyperterminal doesn't like it”

  • Try to connect after and you should be able to get online.
 
en/5667console.txt · Last modified: 2006/02/22 23:25 (external edit)
 
VIF Internet 368 Notre Dame O. suite 200 Montreal QC H2Y 1T9 - 514-353-9988 / sans-frais: 888-321-3737